Explainer · Streets
How Do Traffic Signals Work?
That red light has a schedule, even when it looks arbitrary. Traffic signals balance competing movements using cycles, sensors and carefully timed intervals.
Inside one signal cycle
A traffic signal runs through a cycle: a fixed or variable sequence of phases that give right of way to different movements. The cycle length is the time it takes to complete one full sequence and return to the starting point. Common cycle lengths in American cities range from about 60 to 120 seconds, with some urban intersections running longer.
The split is how much of the cycle each phase receives. A phase that gets 35 seconds of a 90-second cycle has a 39 percent split. Adjusting splits is one of the primary tools engineers use to balance the competing demands of an intersection.
Keeping a corridor in sync
On a corridor with multiple signals, a driver who clears one intersection typically needs to clear the next without stopping. Traffic engineers coordinate adjacent signals by offsetting when each begins its green phase.
If the signal at the next block turns green roughly the time it takes a car to travel between them at the target speed, vehicles that leave the first intersection on green will often arrive at the second one on green as well. The result, when it works, is a ‘green wave’ that moves traffic through multiple intersections without stops.
The difficulty is that a green wave for one direction creates a corresponding red wave for the opposite direction. Engineers choose an offset that best balances all users, which means the result is rarely perfect for any single movement.
When sensors intervene
A fixed-time signal runs the same cycle continuously, regardless of whether traffic is present. Actuated signals use detectors, usually loops buried in the pavement or cameras mounted overhead, to sense vehicles, pedestrians, or cyclists and adjust the timing in response.
A fully actuated intersection can extend a green phase when a queue of vehicles is detected, shorten it when demand drops, and skip phases when no one is present. Delays drop at low-traffic times and service becomes more responsive during peaks.
Pedestrian push buttons, where present, typically trigger a pedestrian phase rather than directly extending the crossing time. The pedestrian demand is registered, but the signal decides when to serve it based on cycle timing.
What timing cannot solve
Every second a movement waits at a red light is delay. The signal cannot give time to everyone at once, so the aggregate delay across all users at an intersection depends on how long the cycle runs, how the splits are assigned, and how often the phases are wasted on empty movements.
Delay is why engineers and planners try to minimize the number of phases and the cycle length at any given intersection while still providing safe crossings for all users. A 120-second cycle at a lightly used intersection where most users arrive infrequently can produce more delay than the intersection needs to carry.
Signal timing balances competing needs, not just cars moving in two directions. Pedestrians need enough time to cross, buses may request priority, turning vehicles require safe opportunities, and queues must not spill into nearby intersections. A shorter red light for one approach can make another approach wait longer. The useful question is what the intersection is optimizing, and whether that objective matches the surrounding street.